NOTE: In the case of simultaneous mounting of wall and floor the correct position of the drill holes result in automatically if the safe, set the desired location and the safe mark the drill holes through the holes in rear panel and the floor. This can be omitted on the drilling template. 2. Place the drilling template with the aid of a water level exactly horizontal and vertical on the selected place and mark the 2 drill holes through the drilling template with a pencil on the wall or floor.NOTE: Before start drilling recheck that positions of the marks on the wall are exactly horizontal and vertical to each other. Drill the holes with diameter 10 mm and a depth of 40 mm. 3. Insert 1 sleeve plug with inserted bolt head at the end of the sleeve plug into each hole in the wall or the floor. (see figure) 4. Hold the safe against the wall or floor, that the holes of the safes each positioned over the drillings on the wall or floor. 5. Then plug the hexagon bolts with flange from the inside through the openings in the back wall / bottom of the safe into the holes of the wall or the floor and tighten the hex bolts. Finally, check whether the safe is fixed and unmoveable connected to the wall or the floor.