For your safety General safety instructions • To operate this device safely, the user must have read and understood these instructions for use before using the device for the first time. • Observe all safety instructions! Failure to do so may cause harm to you and others. • Retain all instructions for use, and safety instructions for future reference. • If you sell or pass the device on, you must also hand over these operating instructions. • The device must only be used when it functions properly. If the product or part of the product is defective, it must be taken out of operation and disposed of correctly. • Never use the device in a room where there is a danger of explosion or in the vicinity of flam-mable liquids or gases. • Always ensure that a device which has been switched off cannot be restarted unintentionally. • Do not use devices with an on/off switch that does not function correctlyKeep children away from the device! Keep the device out of the way of children and other unauthorised persons. • Do not overload the device. Do not use the device for purposes for which it is not intended. • Exercise caution and only work when in good condition: If you are tired, ill, if you have ingested alcohol, medication or illegal drugs, do not use the device, as you are not in a con-dition to use it safely. • This product is not intended to be used by persons (including children) or who are limited in their physical, sensory or mental capacities or who lack experience and/or knowledge of the product unless they are supervised, or have been instructed on how to use the product, by a person responsible for their safety. • Ensure that children are not able to play with the device. • Always comply with all applicable domestic and international safety, health, and working reg-ulations. Electrical safety • The device may only be connected to a socket that is correctly installed and grounded. • The fuse must be a residual current circuit-breaker with a measured residual current of no more than 30 mA. • Make sure that the power supply corresponds with the connection specifications of the device before it is connected. • The tool may only be used within the specified limitations for voltage and power (see type plate). • Do not touch the mains plug with wet hands! Always pull out the mains plug at the plug and not by the cable. • Do not bend, crush, pull or drive over the power cable, protect from sharp edges, oil and heat. • Do not lift the device using the cable or use the cable for purposes other than intended. • Check the plug and cable before each use. • If the power cable is damaged immediately disconnect the plug. Never use the device if the power cable is damaged. • If the device is not in use make sure the plug is pulled outMake sure that the device is switched off before plugging in the mains cable. • Make sure that the device is switched off before unplugging it. • Disconnect the power supply before transporting the device. Device-specific safety instructions • The unit may not be operated indoors. • The unit may not be operated in the vicinity of swimming pools, garden ponds etc. • Do not move the unit when it is in use. • Do not tilt the unit when it is in use. • Never feed objects through the ventilation slots into the unit. Risk to life! • The gap between the ventilation slots and flammable objects must be at least 75 cm. • The unit may not be covered. This causes a risk of fire. • The unit must be assembled on an even, horizontal surface with space surrounding it. The safety gaps must always be adhered to. • Never expose the unit to water or other liquids. • Never use the heater with a timer or another switch that activates the unit automatically as this carries a risk of fire. • The heater may not be set up directly underneath a wall power socket. • Symbols affixed to your unit may not be removed or covered. Information on the unit that is no longer l