CAUTION! Read all the safety information and instructions that were supplied with the FKS 145 guide rail and the power tools used. Failure to comply with safety information and instructions can lead to electric shock, fire and/or serious injury. • Keep the manual in a safe place for future reference.General safety information • DANGER: Disconnect the plug from the electric socket or remove the battery from the power tool before adjusting the tool or changing accessories. Accidents may occur if the power tool is started unintentionally. • Keep your work area clean and well lit. Untidy or dark work areas can lead to accidents. • Before starting work, check that the devices and tools are operational. Never work with damaged or blunt tools. • Remove the adjusting tools or spanners before switching on the power tool. A tool or spanner left in a rotating part of the device can cause injury. • Pay close attention. Do not use a power tool if you are tired or under the influence of drugs, alcohol or medication. A moment of inattention when using the power tool can result in serious injuries. • Wear suitable personal protective equipment: ear protection, safety goggles and dust mask if the work generates dust. • Wear suitable clothing. Never wear loose clothing or jewellery. Keep long hair, clothing, jewellery and gloves away from moving parts. • Keep children and other persons at a safe distance when using the power tool. If you are distracted, you may lose control of the device. • When not in use, store power tools out of reach of children. Do not allow persons to use the tool who are not familiar with it or who have not read these instructions. Power tools are dangerous if used by unexperienced persons. • Do not use the tool on materials other than wood or easily machined plastics. • The machines used must comply with DIN EN 62841-5. • Only use tools for their actual intended purpose. • Ensure that the guide rail is used on a stable, level surface. • The guide rail must not be modified to accommodate other machines on the rail. • Use only the mounting carriage supplied and no older versions/in-house designs. • Check regularly that all screws on the mounting carriage are securely fastened. • Remove the circular hand saw from the mounting carriage in the start/end position only (with the safety shield closed) and after the saw blade has come to a complete stop.Safety information for circular hand saws • In addition to this tool-specific safety information, make sure to observe the safety information for the circular hand saw used. • DANGER: Do not place your hands in the sawing area or on the saw blade. • Use only circular hand saws with a saw blade diameter of min. 130 mm to max. 200 mm, a cutting depth of 40 mm to max. 70 mm and the minimum/maximum base plate dimensions according to Figure 5. • Support long workpieces on the receiving side so that they lie flat; e.g. with a wolfcraft roller trestle (art. no. 6119973). • Avoid overloading the circular hand saw. • Do not use grinding wheels. • Connect the dust extraction system to the circular hand saw (if available). • Use only recommend saw blades and select them depending on the material to be sawn. • When sawing, always be prepared for the saw blade to catch the workpiece and hurl it against the operator. • Recoil is the result of incorrect and/or inappropriate use of the saw. It can be prevented through suitable precautions, as described below. • Hold the saw securely with both hands and place your arms in a position where you can absorb the recoil forces. Always position yourself to the side of the saw blade, never bring the saw blade in line with your body. Recoil can cause the circular saw to jump backwards. • If the saw blade jams or you interrupt your work, switch off the saw and keep it in the material until the saw blade has come to a complete stop. Never attempt to remove the saw from the workpiece or pull it back
